This page was exported from Exams Labs Braindumps [ http://blog.examslabs.com ] Export date:Fri Jul 5 18:11:08 2024 / +0000 GMT ___________________________________________________ Title: Cisco New 2022 350-801 Sample Questions Reliable 350-801 Test Engine [Q135-Q155] --------------------------------------------------- Cisco New 2022 350-801 Sample Questions Reliable 350-801 Test Engine Feel Cisco 350-801 Dumps PDF Will likely be The best Option NEW QUESTION 135Which configuration step is necessary for a Cisco SIP phone to synchronize its time with a specific source?  Add a Phone NTP Reference to the Date/Time Group.  Assign the device to the correct region.  Change the Time Format from 24-hour to 12-hour.  Change the Time Zone from “America/Los_Angeles” to “Etc/GMT+8”. Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmcfg/ CUCM_BK_C95ABA82_00_admin-guide-100/CUCM_BK_C95ABA82_00_admin-guide-100_chapter_0110.htmlNEW QUESTION 136When configuring Cisco Unified Communications Manager, which configuration enables phones to automatically register to a Cisco Unified Communications publisher when the connection to the subscriber is lost?  Cisco Unified CM Group  Device Pool  SRST  Route Group NEW QUESTION 137Refer to the exhibit.A customer submits this output, captured on a Cisco IOS router. Assuming that an MGCP gateway is configured with a ISDN BRI interface, which BRI changes resolve the issue?A)B)C)D)  Option A  Option B  Option C  Option D NEW QUESTION 138An engineer encounters third-party devices that do not support Cisco Discovery Protocol. What must be configured on the network to allow device discovery?  LACP  TFTP  LLDP  SNMP Section: Protocols, Codecs, and EndpointsExplanationNEW QUESTION 139Refer to the exhibit.A collaboration engineer is configuring the Cisco UCM IM and Presence Service. Which two steps complete the configuration of the SIP trunk security profile? (Choose two.)  Check the box to accept replaces header.  Check the box to allow charging header.  Check the box to enable application-level authorization.  Check the box to transmit security status.  Check the box to accept unsolicited notification. NEW QUESTION 140Which call flow matches traffic from a Mobile and Remote Access registered endpoint to central call control?  Endpoint > Expressway-C > Cisco unified CM  Endpoint > Expressway-E > Cisco Unified CM  Endpoint > Expressway-C > Expressway-E > Cisco Unified CM  Endpoint > Expressway-E > Expressway-C > Cisco Unified CM NEW QUESTION 141A SIP phone has been configured in the system with MAC address 0030 96D2 D5CB The phone retrieves the configuration file from the Cisco UCM. Which naming format is the file that is downloaded?  SIPOO3O96D2D5CB.cnf.xml  SEP003096D2D5CB.cnf.xml  SEP0030406706705.cnf  SIP0030406706705.cnf NEW QUESTION 142Which action is required for a firewall configuration on a Mobile and Remote Access through Cisco Expressway deployment?  The traversal zone on Expressway-C points to Expressway-E through the peer address field on the traversal zone, which specifies the Expressway-E server address. For dual NIC deployments, set the Expressway-E address using an FQDN that resolves the IP address of the internal interface  The internal firewall must allow these inbound and outbound connections between Expressway-C and Expressway-E. SIP: HTTPS (tunnelled overSSH between C and E): TCP 2222; TCP 7001; Traversal Media: UDP 2776 to 2777 (or 36000 to 36011 for large VM/appliance): XMPP: TCP 7400.  The external firewall must allow these inbound connections to Expressway: SIP: TCP 5061; HTTPS: TCP 8443: XMPP: TCP 5222; Media: UDP 36002 to 59999.  Do not use a shared address for Expressway-E and Expressway-C, as the firewall cannot distinguish between them If static NAT for IP addressing on Expressway-E is used, ensure that any NAT operation on Expressway-C does not resolve the same traffic IP address Shared NAT is not supported. NEW QUESTION 143Which issue causes slips on a PRI?  incorrect clock source  incorrect encapsulation  incorrectly configured time zone  change in the line code Section: Infrastructure and DesignNEW QUESTION 144Drag and drop the SNMPv3 messages types from the left onto the corresponding definitions on the right. NEW QUESTION 145According to the QoS Baseline Model, drag and drop the applications form the left onto the correct per-Hop Behaviour values on the right. NEW QUESTION 146An engineer configures local route group to simplify a dial plan. Where does the engineer set the route groups according to the local route group names that are configured?  CSS  route pattern  device pool  route list NEW QUESTION 147An end user at a remote site is trying to initiate an Ad Hoc conference call to an end user at the main site. The conference receives an error message on the phone: Cannot complete conference call. What is the cause of the issue?  The transcoder resource Is missing.  The remote phone does not have the conference feature assigned  A software conference bridge is not assigned.  A Media Termination Point is missing. NEW QUESTION 148An engineer must manually register an analog port with cisco UCM using the MGCP protocol. Which commands are required?  Option A  Option B  Option C  Option D NEW QUESTION 149Which configuration tells a switch port to send Cisco Discovery protocol packets that configure an attached Cisco IP phone to trust tagged traffic that is received from a device that is connected to the access port on the Cisco IP phone?A)B)C)D)  Option A  Option B  Option C  Option D NEW QUESTION 150What is a valid class included in the 8-Class QoS Strategy in a VoIP network?  Assured Forwarding  Broadcast Video  Multimedia Conferencing  Real-Time Interactive Explanation/Reference: https://www.ciscopress.com/articles/article.asp?p=2756478&seqNum=8NEW QUESTION 151A DTMF mismatch is occurring between an MGCP gateway registered FXS port and a Cisco Unified communications Manager SIP trunk. Which media resource can be leveraged to interwork this mismatch?  Media Termination point  Conference Bridge  Annunciator  Trusted relay point NEW QUESTION 152Which protocols does Cisco IM and Presence use to authenticate Jabber?  XMPP  SOAP  TCP  LDAP  QBE NEW QUESTION 153An administrator has been asked to implement toll fraud prevention in Cisco UCM Which tool is used to begin this process?  Cisco UCM class of service  Cisco Unified Mobility  Cisco UCM Access Control Group restrictions  Cisco Unified Real-Time Monitoring Tool NEW QUESTION 154Refer to the exhibit.When making a call to a MRA client, what are the combinations of protocol on each of the different sections A-B-C?  IP TCP/TLS(A) +SIP TCP/TLS (B) +TLS (C)  SIP TLS (A) +SIP TLS (B) +SIP TLS (C)  SIP TCP/TLS (A) + SIP TLS (B) + SIP TLS (C)  SIP TCP/TLS +SIP TCP/TLS (B) + SIP TCP/TLS (C) NEW QUESTION 155Which action is required if an engineer wants to have Cisco Unified Communications Manager configuration for an MGCP gateway?  Upload the custom configuration in the TFTP server in cisco Unified CM.  Configure the Cisco Unified CM’s IP in voice service VoIP.  Apply the ccm-manager configuration commands to the gateway.  From Cisco Unified CM >Device > Gateway > Add gateway, check the auto-configuration check box.  Loading … Use Valid New 350-801 Test Notes & 350-801 Valid Exam Guide: https://www.examslabs.com/Cisco/CCNP-Collaboration/best-350-801-exam-dumps.html --------------------------------------------------- Images: https://blog.examslabs.com/wp-content/plugins/watu/loading.gif https://blog.examslabs.com/wp-content/plugins/watu/loading.gif --------------------------------------------------- --------------------------------------------------- Post date: 2022-06-06 13:14:12 Post date GMT: 2022-06-06 13:14:12 Post modified date: 2022-06-06 13:14:12 Post modified date GMT: 2022-06-06 13:14:12