[Jul 12, 2022] Valid 200-301 Test Answers & 200-301 Exam PDF [Q252-Q270]

July 12, 2022 200-301, Cisco 0 Comments

[Jul 12, 2022] Valid 200-301 Test Answers & 200-301 Exam PDF [Q252-Q270]

4.2/5 - (4 votes)

[Jul 12, 2022] Valid 200-301 Test Answers & 200-301 Exam PDF

Valid CCNA 200-301 Dumps Ensure Your Passing

NO.252 Refer to the exhibit.

Packets received by the router from BGP enter via a serial interface at 209.165.201.10. Each route is present within the routing table. Which interface is used to forward traffic with a destination IP of 10.10.10.24?

F0/10

F0/11

F0/12

F0/13

NO.253 Refer to the exhibit.

An engineer has started to configure replacement switch SW1. To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing. Which change must be applied to SW1 so that PC1 and PC2 communicate normally?
A)

B)

C)

D)

Option A

Option B

Option C

Option D

NO.254 Refer to the exhibit.

What two conclusions should be made about this configuration? (Choose two )

The designated port is FastEthernet 2/1

This is a root bridge

The spanning-tree mode is Rapid PVST+

The spanning-tree mode is PVST+

The root port is FastEthernet 2/1

NO.255 Refer to the exhibit.

What is the effect of this configuration?

The switch port interface trust state becomes untrusted

The switch port remains administratively down until the interface is connected to another switch

Dynamic ARP inspection is disabled because the ARP ACL is missing

The switch port remains down until it is configured to trust or untrust incoming packets

Dynamic ARP inspection (DAI) is a security feature that validates ARP packets in a network. It intercepts, logs, and discards ARP packets with invalid IP-to-MAC address bindings. This capability protects the network from certain man-in-the-middle attacks. After enabling DAI, all ports become untrusted ports.

NO.256 A router running EIGRP has learned the same route from two different paths Which parameter does the router use to select the best path?

cost

adminstrative distance

metric

as-path

Explanation
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/

NO.257 How does NAT overloading provide one-to-many address translation?

It uses a pool of addresses

It converts IPV4 addresses to unused IPv6 Addresses

It assigns a unique TCP/UDP port to each session

It uses virtual MAC Address and Virtual IP Addresses

NO.258 Refer to the exhibit.

A packet is being sent across router R1 to host 172.163.3.14. To which destination does the router send the packet?

207.165.200.246 via Serial0/1/0

207.165.200.254 via Serial0/0/1

207.165.200.254 via Serial0/0/0

207.165.200.250 via Serial/0/0/0

NO.259 Which two authentic methods are compatible with MLPPP on a serial Interface? (choose two)

PEAP

CHAP

TACACS+

PAP

LEAP

NO.260 Refer to the exhibit.

A packet is being sent across router R1 to host 172.163.3.14. To which destination does the router send the packet?

207.165.200.246 via Serial0/1/0

207.165.200.254 via Serial0/0/1

207.165.200.254 via Serial0/0/0

207.165.200.250 via Serial/0/0/0

NO.261 Refer to the exhibit.

A network engineer must block access for all computers on VLAN 20 to the web server via HTTP All other computers must be able to access the web server Which configuration when applied to switch A accomplishes this task?

Option A

Option B

Option C

Option D

NO.262 Refer to the exhibit. Which command provides this output?

show ip route

show ip interface

show interface

show cdp neighbor

NO.263 Drag and drop the attack-mitigation techniques from the left onto the Types of attack that they mitigate on the right.

NO.264 Refer to the exhibit.

Which prefix does Router 1 use for traffic to Host A?

10.10.10.0/28

10.10.13.0/25

10.10.13.144/28

10.10.13.208/29

Host A address fall within the address range. However, if more than one route to the same subnet exist (router will use the longest stick match, which match more specific route to the subnet). If there are route 10.10.13.192/26 and 10.10.13.208/29, the router will forward the packet to /29 rather than /28.

NO.265 Refer to the exhibit. A network engineer must block access for all computers on VLAN 20 to the web server via HTTP. All other computers must be able to access the web server.
Which configuration when applied to switch A accomplishes this task?

NO.266 Which MAC address is recognized as a VRRP virtual address?

0000.5E00.010a

0005.3711.0975

0000.0C07.AC99

0007.C070/AB01

With VRRP, the virtual router’s MAC address is 0000.5E00.01xx , in which xx is the VRRP group.

NO.267 Refer to the exhibit.

An IP subnet must be configured on each router that provides enough addresses for the number of assigned hosts and anticipates no more than 10% growth for now hosts. Which configuration script must be used?
A)

B)

C)

D)

Option A

Option B

Option C

Option D

NO.268 Refer to the exhibit.

Which two statements about the network environment of router R1 must be true? (choose two)

there are 20 different network masks within the 10.0.0.0/8 network

A static default route to 10.85.33.14 was defined

Ten routes are equally load-balanced between Te0/1/0.100 and Te0/2/0.100

The 10.0.0.0/8 network was learned via external EIGRP

The EIGRP administrative distance was manually changed from 90 to 170

NO.269 Which value can you modify to configure a specific interface as the preferred forwarding interface?

The interface number

The port priority

The VLAN priority

The hello time

NO.270 Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?

Bronze

Platinum

Silver

Gold

Loading …

Test Objectives

While the CCNA exam will be mainly focusing on network fundamentals, it also covers a series of technical topics that will be key to helping you become an all-round IT nerd. In summary, here’s what the 200-301 exam curriculum will address:

Automation and Programmability;
IP Services;
Security Basics;
Network Access.
IP Connectivity;

What’s Next Step?

The CCNA certification is of the associate level, so there’s enough ground to advance your knowledge and skills. After passing 200-301 exam and obtaining the certificate, you can select advanced-level learning paths that align with your career goals. The most suitable option is always the professional-level certifications, specifically the new CCNP Enterprise. Check out the Cisco webpage to find out more information about the whole career path.

200-301 Dumps Real Exam Questions Test Engine Dumps Training: https://www.examslabs.com/Cisco/CCNA/best-200-301-exam-dumps.html