Valid DES-DD23 Exam Dumps Ensure you a HIGH SCORE (2022) [Q11-Q33] : Exams Labs Braindumps : http://blog.examslabs.com

Q11. Which component of PowerProtect DD is Data Invulnerability Architecture a feature of?

VTL

DDOS

DD Boost

CIFS

Q12. What is the order of steps to configure DD Boost on the backup host?

Q13. An administrator recognizes poor network performance when using CIFS shares from a PowerProtect DD system. The network link utilization is under 100%.
What is the most likely cause of this issue?

TCP window size too small

TCP timeout too small

TCP timeout too large

TCP window size too large

Q14. Backup administrators have noticed slow backups on the AIX environment.
To fix the issue, what should the set large_send be for each NIC, and what should the NFS option be set to?

no and nfs_rfc1323=0

yes and nfs_rfc1323=0

no and nfs_rfc1323=1

yes and nfs_rfc1323=1

Q15. An administrator monitors the performance statistics of a PowerProtect DD appliance. Low disk-write rates are shown, and the network inbound traffic is high.
What is the most likely cause of this behavior?

NVRAM failure

Disk failure

Expired segments

Known segments

Q16. A PowerProtect DD appliance has been installed at a company’s location for several months and has reached a steady state.
As a best practice, at what percentage of disk utilization should action be taken?

60%

70%

80%

95%

Q17. What system role is required to create the second security officer for a PowerProtect DD?

admin

sysadmin

limited-admin

security officer

Q18. What are some possible network bottlenecks for a PowerProtect DD?

Configuration, wire speeds, switches and routers

Connectivity, routing protocols, and configuration

Connectivity, firewalls, and routing protocols

Routing protocols, switches and routers, and wire speeds

Q19. Which are supported compression algorithms in DDOS?

lz, gz, and gzfast

dsp, gz, and lz

rle, lzw, and lz

bmp, lz, and gz

Q20. An engineer is configuring a PowerProtect DD system for VTL using Fibre Channel. How should the zones be configured?

Hard zones

Single initiator, multi target

Single initiator, single target

Soft zones

Q21. A customer needs an upgrade on their DD6900 to use HA.
Which expansion shelf is required?

ES40

FS25

DS60

ES25

Q22. Refer to the exhibit.

Match each action to its call-out location.

Q23. Which command is used to check if NFS is enabled?

nfs enable

nfs status

nfs show clients

system show

Q24. Which PowerProtect DD procedure uses the DoD/NIST standards to provide data security?

Data Sanitization

End-to-End Verification

Replication Encryption

Encryption

Q25. A PowerProtect DD appliance with two expansion shelves is being installed in a customer-provided rack. When cabling the controller to the shelves, what is connected to the host port on the last shelf in the chain?

Expansion port of the upstream shelf

Host port of the controller

Expansion port of the controller

Host port of the downstream shelf

Q26. What is the maximum capacity for a DDVE?

64 TB

96 TB

128 TB

256 TB

Q27. What is a requirement to configure the PowerProtect DD tape out to cloud feature?

Two cloud units

Cloud Tier Capacity License

Tape Out to Cloud License

DDVE in the Cloud

Q28. Which port/protocol is used when using a syslog server to monitor a PowerProtect DD system?

514/UDP

2051/TCP

514/TCP

2051/UDP

Q29. When using CIFS from a PowerProtect DD system, what should be changed on a Windows machine?

SMBTimeout to 7200 seconds

CIFSTimeout to 3600 seconds

SESSTIMEOUT to 7200 seconds

SESSTIMEOUT to 3600 seconds

Q30. What is the correct sequence of operations used by the PowerProtect DD DIA in the end-to-end verification process?

Q31. An administrator is scaling Cloud Tier for a DD9400 by adding a second cloud unit. What is the required amount of metadata storage (TB)?

120

240

300

500

Q32. A backup administrator is tasked with verifying the compression savings of a PowerProtect DD9900. Which compression algorithm will they see enabled by default?

lzw

gzfast