This page was exported from Exams Labs Braindumps [ http://blog.examslabs.com ] Export date:Sat Nov 23 11:01:11 2024 / +0000 GMT ___________________________________________________ Title: Valid DES-DD23 Exam Dumps Ensure you a HIGH SCORE (2022) [Q11-Q33] --------------------------------------------------- Valid DES-DD23 Exam Dumps Ensure you a HIGH SCORE (2022) Pass DES-DD23 Exam with Latest Questions Q11. Which component of PowerProtect DD is Data Invulnerability Architecture a feature of?  VTL  DDOS  DD Boost  CIFS Q12. What is the order of steps to configure DD Boost on the backup host? Q13. An administrator recognizes poor network performance when using CIFS shares from a PowerProtect DD system. The network link utilization is under 100%.What is the most likely cause of this issue?  TCP window size too small  TCP timeout too small  TCP timeout too large  TCP window size too large Q14. Backup administrators have noticed slow backups on the AIX environment.To fix the issue, what should the set large_send be for each NIC, and what should the NFS option be set to?  no and nfs_rfc1323=0  yes and nfs_rfc1323=0  no and nfs_rfc1323=1  yes and nfs_rfc1323=1 Q15. An administrator monitors the performance statistics of a PowerProtect DD appliance. Low disk-write rates are shown, and the network inbound traffic is high.What is the most likely cause of this behavior?  NVRAM failure  Disk failure  Expired segments  Known segments Q16. A PowerProtect DD appliance has been installed at a company’s location for several months and has reached a steady state.As a best practice, at what percentage of disk utilization should action be taken?  60%  70%  80%  95% Q17. What system role is required to create the second security officer for a PowerProtect DD?  admin  sysadmin  limited-admin  security officer Q18. What are some possible network bottlenecks for a PowerProtect DD?  Configuration, wire speeds, switches and routers  Connectivity, routing protocols, and configuration  Connectivity, firewalls, and routing protocols  Routing protocols, switches and routers, and wire speeds Q19. Which are supported compression algorithms in DDOS?  lz, gz, and gzfast  dsp, gz, and lz  rle, lzw, and lz  bmp, lz, and gz Q20. An engineer is configuring a PowerProtect DD system for VTL using Fibre Channel. How should the zones be configured?  Hard zones  Single initiator, multi target  Single initiator, single target  Soft zones Q21. A customer needs an upgrade on their DD6900 to use HA.Which expansion shelf is required?  ES40  FS25  DS60  ES25 Q22. Refer to the exhibit.Match each action to its call-out location. Q23. Which command is used to check if NFS is enabled?  nfs enable  nfs status  nfs show clients  system show Q24. Which PowerProtect DD procedure uses the DoD/NIST standards to provide data security?  Data Sanitization  End-to-End Verification  Replication Encryption  Encryption Q25. A PowerProtect DD appliance with two expansion shelves is being installed in a customer-provided rack. When cabling the controller to the shelves, what is connected to the host port on the last shelf in the chain?  Expansion port of the upstream shelf  Host port of the controller  Expansion port of the controller  Host port of the downstream shelf Q26. What is the maximum capacity for a DDVE?  64 TB  96 TB  128 TB  256 TB Q27. What is a requirement to configure the PowerProtect DD tape out to cloud feature?  Two cloud units  Cloud Tier Capacity License  Tape Out to Cloud License  DDVE in the Cloud DD VTL supports storing the VTL vault on Cloud Tier storage. To use this functionality, the protection system must be a supported Cloud Tier configuration, and have a Cloud Tier license in addition to the VTL license.Q28. Which port/protocol is used when using a syslog server to monitor a PowerProtect DD system?  514/UDP  2051/TCP  514/TCP  2051/UDP Q29. When using CIFS from a PowerProtect DD system, what should be changed on a Windows machine?  SMBTimeout to 7200 seconds  CIFSTimeout to 3600 seconds  SESSTIMEOUT to 7200 seconds  SESSTIMEOUT to 3600 seconds Q30. What is the correct sequence of operations used by the PowerProtect DD DIA in the end-to-end verification process? Reference:https://www.dell.com/community/Data-Domain/Introducing-data-protection-technology-DIA-of-Data-Domain/td- p/6960086Q31. An administrator is scaling Cloud Tier for a DD9400 by adding a second cloud unit. What is the required amount of metadata storage (TB)?  120  240  300  500 Q32. A backup administrator is tasked with verifying the compression savings of a PowerProtect DD9900. Which compression algorithm will they see enabled by default?  lzw  gzfast  lz  gz  Loading … DES-DD23 Exam Practice Questions prepared by EMC Professionals: https://www.examslabs.com/EMC/Dell-Certified-Specialist/best-DES-DD23-exam-dumps.html --------------------------------------------------- Images: https://blog.examslabs.com/wp-content/plugins/watu/loading.gif https://blog.examslabs.com/wp-content/plugins/watu/loading.gif --------------------------------------------------- --------------------------------------------------- Post date: 2022-10-20 09:59:05 Post date GMT: 2022-10-20 09:59:05 Post modified date: 2022-10-20 09:59:05 Post modified date GMT: 2022-10-20 09:59:05