[Jun 25, 2023] New Huawei H35-460-ENU Dumps with Test Engine and PDF (New Questions) [Q112-Q133]

QUESTION 112
The calculation formula of the absolute frequency of gNodeB cell is similar to that of LTE, and the value of ΔF is also the same.

QUESTION 113
Which of the following objects cannot be occluded with BLK?

QUESTION 114
What is the broadcast period of MIB messages in NR?

QUESTION 115
In the NSA networking scenario, gNodeB does not need to configure the X2 interface.

QUESTION 116
Which of the following modules supports 64T64R?

QUESTION 117
Under the EN-DC architecture, the eNodeB/gNodeB only supports the configuration of the X2 finger based on the EndPoint method.

QUESTION 118
DCDU-12B is a DC power distribution unit. How much DC power input is provided for each component in the cabinet?

QUESTION 119
When debugging the NR base station through the near end of the USB flash drive, which of the following conditions will cause the RU indicator of the main control board to be in the “load failed” state?

QUESTION 120
What is the maximum rate supported by the addition of Ethernet ports to the gNodeB main control board?

QUESTION 121
During the 5G test, if the PC is directly connected to the LAN port of Huawei CPE through the network cable, the IP address must be manually configured on the PC to be normal

QUESTION 122
What are the networking methods between the BBU and the RF unit? (Multiple Choice)

QUESTION 123
What is wrong with the description of AAU5613?

QUESTION 124
Which of the following half-width 5G baseband boards are supported by the BBU5900 in the V100R015 version?

QUESTION 125
What is the fiber pulling capacity between AAU and BBU using eCPRI schemes

QUESTION 126
What is wrong with the description of the Mandarin Duck Line test on the U2000?

QUESTION 127
What data configuration tools can gNodeB use to complete the station? (Multiple choice)

QUESTION 128
Which description of NR time domain resources is correct?

QUESTION 129
Regarding the DMRS of the PDSCH, what are the correct descriptions of the following? (Multiple Choice)

QUESTION 130
In the steps of replacing UMPT, which of the following needs to be done first?

QUESTION 131
In the 5G RAN2.0 version, what is the maximum number of 100MHz 64*64 cells supported by a single BBU900?

QUESTION 132
5G RAN 2.0 version gNodeB logical cells and sector devices use the command ANDD NRDUCELLTRP to complete the binding.

QUESTION 133
Which device makes the judgment on the change of auxiliary station under the NSA architecture?