Q18. Which three requirements are needed to provision an additional cluster within VMware Cloud Foundation? (Choose three.)

Q19. A VCF architect collected the following requirements when designing the expansion of a new VI Workload Domain with twenty four vSAN Ready nodes, each with a dual-port 25Gbps network interface card:
* Provide scalable high-performance networking with layer-3 termination at top-of-rack
* Protect workloads from switch/NIC/rack failure
* Provide isolation for DMZ workloads
* Provide at-least 25Gbps dedicated bandwidth to backup traffic
* Easily accept workloads on traditional VLAN-backed networks
* Fully-supported by VMware
Which three design considerations meet all of these requirements? (Choose three.)

Q20. A VMware Cloud Foundation administrator is required to enable Workload Management (vSphere with Tanzu) on an existing workload domain cluster, which is currently licensed with a vSphere Enterprise Plus license.
Which action, if any, is required to complete this task?

Q21. An architect is designing networking for a developer-ready infrastructure on VMware Cloud Foundation.
During the discussion with the network team, a question comes up about the use of a routable CIDR range.
Which item uses this type of range?

Q22. A VMware Cloud Foundation (VCF) architect is presented with a customer’s requirements for an architecture that needs to achieve:
* Network high availability across workloads in two data center locations.
* Maintain the least administrative overhead when performing day 2 operations.
* Decrease the RTO of both management plane and data plane when site-wide failure occurs Which VCF design consideration should the architect recommend?

Q23. An administrator has registered an external identity source in a consolidated architecture and would like to make sure that any subsequent workload domains can be accessed using the same identity sources.
How can this goal be achieved with VMware Cloud Foundation?

Q24. During a VCF design workshop, the architect gathered the following customer requirements:
* There must be two environments: PROD and DEV.
* PROD and DEV should be administratively separated.
* PROD will use two different hardware server types, and DEV will only use one hardware server type.
* The VCF infrastructure design should be flexible and scalable as much as possible How many NSX local managers in total will be provisioned after deploying the full VCF infrastructure?

Q25. A VMware Cloud Foundation (VCF) architect is presented with a customer’s requirements for an architecture that needs to achieve:
* Network high availability across workloads in two data center locations.
* Maintain the least administrative overhead when performing day 2 operations.
* Decrease the RTO of both management plane and data plane when site-wide failure occurs Which VCF design consideration should the architect recommend?

Q26. Which two options can be used to create a new VMware Cloud Foundation VI workload domain? (Choose two.)

Q27. What is the correct upgrade order for VMware Cloud Foundation (VCF) components for a VI workload domain with a stretched vSAN cluster?

Q28. A VMware administrator is tasked to upgrade a VMware Cloud Foundation (VCF) environment that is running on DellEMC PowerEdge servers.
During the ESXi software upgrade for the VI Workload Domain hosts, the administrator receives an error stating that the correct storage driver is not available, although the storage adapters are enabled in the BIOS.
Which action should the administrator take to fix this issue?

Q29. An administrator has registered an external identity source in a consolidated architecture and would like to make sure that any subsequent workload domains can be accessed using the same identity sources.
How can this goal be achieved with VMware Cloud Foundation?

Q30. Which license is required to enable Workload Management on VMware Cloud Foundation?

Q31. Which order of steps should an administrator use to replace a failed host in a stretched cluster?

Q32. What is required as part of enabling the Harbor Image Registry?

Q33. A vSphere administrator is tasked with enabling Workload Management on a VMware Cloud Foundation Workload Domain.
Which three components are configured as part of the Supervisor Cluster control plane after this task is completed? (Choose three.)

Q34. VCF design workshops were conducted, and the architect collected the following customer requirements for the newly planned VCF infrastructure:
* The new VCF infrastructure must target two zones: DEV/UAT and DMZ.
* The security team would like to have full management and network isolation between these two zones
* 12 hosts have been ordered for the solution.
* DEV/UAT workloads must comply with an erasure coding vSAN storage policy with the ability to tolerate the failure of two hosts.
Which workload domain sizing will be required to achieve these requirements?

Q35. A developer is deploying pods with Persistent Volumes (PV) on vSphere with Tanzu. Which component determines the datastore that the PV will be placed on?