Check Real HP HPE7-A07 Exam Question for Free (2024) [Q41-Q64] : Exams Labs Braindumps : http://blog.examslabs.com

This page was exported from Exams Labs Braindumps [ http://blog.examslabs.com ]
Export date: Thu Nov 21 13:33:34 2024 / +0000 GMT

Check Real HP HPE7-A07 Exam Question for Free (2024) [Q41-Q64]

Check Real HP HPE7-A07 Exam Question for Free (2024)

Get Ready to Boost your Prepare for your HPE7-A07 Exam with 70 Questions

NEW QUESTION 41
Exhibit.

Which statement is true given the following CLI output from a CX 6300?

There are no active fabric clients on the CX switch with RD 172.16.10.1

A wired client with IP address 10.203 1.100 is on a remote CX 6300 in the fabric with loopback IP address 172.21.11.2.

A wired client with IP address 10 203 1 100 has a host route that is not being properly advertised

The overlay loopbacK addresses are advertised in the faerie with 2d-bit subnet masks

NEW QUESTION 42
A deployment using AP-635S is connectedto a stack of CX 6300s as shown.

The output of the snow LACPinterfaces shews the following:

What is causing this issue?

e0 is connected to a smart rate interface, and e1 is connected to a non-smart rate interface.

Spanning tree and loop protect are enabled on both AP uplink ports.

Each AP interface is connected to a routed-only interlace on different networks

The AP is configured with LACP active

NEW QUESTION 43
A customer wan a gateway connected to a device on gigabitethernet0/0/3 configures an Asset ID TLVon the device for inventory management.
Exhibit.

The customer mentions me Asset ID is not shown What is causing the issue?

LLDP TX is not enabled.

LLPD-MED needs to be enabled.

MTU size is too small.

Unknown TLVs cannot be displayed.

NEW QUESTION 44
A customer is deploying a new warehouse with AP-634 APs inthe unitedStates with mobile devices that can operate in the 6GHz spectrum All testing and RF analyses were performed during the POC using AP-635 APs In a different location During the deployment, they noticed fewer 6GHz channels were broadcasting in the air.
Why would the AP-634 deployment have a lesser amount of broadcasting channels?

The AP-634 APs do not have an advanced subscription.

The AP-634 APs cannot broadcast an 6Gnz channels due to regulatory restrictions.

The AP-635 APs received different allowable 6GHz channels from the AFC service versus the AP-634 APs due to the POC running in a different location.

The AP-634 AP’s persona was configured in the Central group as Standard Power.

NEW QUESTION 45
You are testing the use of the automated port-access role configuration process using RadSec authentication over VXLAN. During your testing you observed that the RadSec connection will fan during the digital certificate exchange What would be the cause of this Issue?

The RadSec server was defined on the switch using an IPv6 address that was unreachable

Tracking mode was set to “dead-only”, and the RadSec server was marked as unreachable.

The switch is configured to establish a TLS connection with a proxy server, not the radius server.

The RADIUS TCP packets are Being dropped and the TLS tunnel is not established.

NEW QUESTION 46
The ACME company has an AOS-CX 6200 switch stack with an uplink oversubscription ratio of 9.6:1. They are considering adding two more nodes to the stack without adding any additional uplinks due to cabling constraints One oftheir architects has expressed concerns that their critical UDP traffic from both wired and bridged AP clients will encounter packet drops.They have already applied the following configuration:

Which strategy will complement this solution to achieve their objective?

edge mark lower priority TCP traffic with AF12

edge mark critical UDP Traffic with CSS

edge mark lower priority TCP traffic with AF11

edge mark critical UDP traffic with AF42

NEW QUESTION 47
Refer to the CLI output below:

What statement about the output above is correct?

The port-access role was configured with gateway-role visitor

The secondary tunnel endpoint IP is 10.10-10.151.

The client authenticated using dot1x.

The UBT zone was configured to use a user-defined VRF

NEW QUESTION 48
Which statement is true given the following CLIoutput from a CX 6300?

The underlay loopback addresses are in the 172 21 11 x range.

There are two anycast addresses m me overlay fabric.

Duplicate MAC addresses were detected in the overlay fabric

There are three active client overlay VLANs in the overlay fabric

NEW QUESTION 49
A BGP routing tablecontains multiple routes to the same destination prefix.
Referring to the table below whichroutewould be marked with a “>” symbol?

Option A

Option B

Option C

Option D

Option E

NEW QUESTION 50
A customer’s infrastructure is set up to use both primary and secondary gateway clusters on the SSID profile based on best practices What is a valid cause tor having an equal spirt in APs connected to the primary and secondary gateway clusters?

The secondary gateway cluster is heterogeneous

The secondary gateway cluster is homogeneous

The primary gateway cluster is up. out some APs are unable to reach the primary gateway cluster. These APs would connect to the secondary gateway cluster

The primary gateway cluster is up. out some APs cannot reach the secondary gateway cluster. These APs would connect to the secondary gateway cluster

NEW QUESTION 51
Exhibit.

After configuring VRRP between sw-1 and SW-2. you notice that both switches are showing as active. What could be the reason for this issue?

VRRP preemptive mode is disabled.

SW-1 cam reach SW-2 on VLAN 10.

Both switches are configured as VRRP ‘primary.’

SW-2 has no priority configurations for VRRP 1.

NEW QUESTION 52
A customer has deployed anAOS 10 mobilitygateway cluster consisting of three controllers at a single site The WLAN is configured to tunnel wireless device traffic to the AOS 10 mobilitycluster.The clients areauthorized to use WPA2-Personal.An end-userhas opened a ticket with the helpdesk stating they cannot connect their client device to the network.There are other devices currently associated with the SSID with no issues.

Reviewing the output, what Is the issue?

The RADIUS response from the authentication server is

The client device has an invalid certificate

The client device has an invalid pre-shared key.

transition mode is not enabled

NEW QUESTION 53
Exhibit.

Which wireless connection phase has Just been completed?

MAC Authentication and 4-way handshake

L3 authentication and encryption

802.11 enhanced open association

L2 authentication and encryption

NEW QUESTION 54
What directly affects the MCS used by wireless stations? (Select two.)

SNR

retry rate

channel utilization

number of connected clients

frequency band

NEW QUESTION 55
After onboarding three new AOS 10 gateways using the full-setup methodinto the same Central group, a customer cannot log in to one of the gateways using the HPE Aruba Networking Central remote console due to an incorrect password.

The admin password created using full-setup does not match the global Central admin password.

The admin password created during the run-setup process is not configured to allow me remote console access

The admin password created during the full-setup process does not match the Central group admin password

The admin password created at the Central group level has expired

NEW QUESTION 56
Which option shows the correct Banawidth Control for 1024 kbpsdown and 2048 Kops up for the SSID?

NEW QUESTION 57
A customer has interfering devices that are seen over the air. They contact you and ask you to configure RAPIDS to help identify interfering and rogue APs. HPE Aruba Networking Central identifies a rogue AP and displays the connected switch port.
How can HPE Aruba Networking Central identify which switch port the AP is connected to?

device profiting on the switch

from the AP MAC address table

from the switch LLDP neighbors table

from the switch MAC address table

NEW QUESTION 58
Exhibit.

You updated your gateway to me most recent firmware However after the firmware was updated, the gateway could no longer connect to HPE Aruba Networking Central. Your corporate ITIL procedures require you to implement your backout plan. You connected a console cable to your gateway and saw the following prompt.
Cpxload#
in what order, do you need to execute the following commands to return to the previous firmware version?

NEW QUESTION 59
Exhibit.

What is me expected behavior for ARP traffic sent from H1?

A2 will drop the ARP traffic.

A2 will send the ARP traffic out of ports 1/1/1-1/1/4.

A2 willflood the ARP traffic out of all interfaces.

A2 willsend the ARP traffic out of ports 1/1/1 and 1/1/3.

NEW QUESTION 60
What is me recommended configuration to ensure link aggregation is consistent in a campus topology using VSX with two aggregation switches and downlinks to access switches?

Use a custom LACP hash algorithm for improved load Balancing.

Keep the MTU values at the default setting for GRE and VXLAN communications

Use the command “vsx-sync mclag-interfaces” under the VSX context.

Use the command “vsx-sync active-gateways” under the VSX context.

NEW QUESTION 61
Your customer added third-party USB dongles to the USB ports of their AOS 10 access points. The customer uses AP-615 and AP-635 Each AP is connected with a Cat 6A cable to a CX 6300F Class 4 PoE switch All APs are in the same group in HPE Aruba Networking Central and share the same configuration However, many of the dongles do not come up.
Which option will solve this issue?

Replace the Class a PoE switches with Class 6 PoE switches.

Create two separate service profiles in the loT tab of the Central configuration settings.

Perform a “poe disable” followed by a “poe enable” for the switch ports which connect to the APs so that the APs reboot.

Move the AP-635 access points to a different group in Central to configure the dongles separately from the AP-615.

NEW QUESTION 62
You are troubleshooting a WLAN deployment with APs and gateways set up with an 802.1X tunneled SSIO.
End-users are complaining that they can’t connect to die enterprise SSID. Which possible AP tunnel states could be the cause of the Issue? (Select two.)

SM_STATE_RE KEYING

SM_STATE_SURVIVED

SM_STATE_CONNECTED

SM_STATE_SURVIVING

SM_STATE_CONNECTING

NEW QUESTION 63
Exhibit.

An engineer has applied the above configuration to R1 and R2 However the routers OSPF adjacency never progresses past the “EXSTART-DR” slate as shown below.

Which configuration action on either router will allow R1 and R2 to progress past the “EXSTART/DR” state?

Change R1 and R2 to a network type of point-to-point.

Remove the layer 3 MTU configuration.

Ensure the OSPF process is not configured with passive-interface default.

Change the IP address and mask applied to interface 1/1/1.

NEW QUESTION 64
Your customer’s employees connected to a wired network are complaining about a poor user experience. The customer has UXI sensors deployed on their premises. These sensors nave been running for multiple months.
They are testing both the wired network (using the wired Interface of each sensor) and the wireless networks.
Your customer used the UXI dashboard to find the reason for the poor userexperience to find more details, the customer asked you to check the packet captures that have been downloaded from the sensors using the UXI dashboard.
From the zip file downloaded from the UXI sensors, you checked the “datagrams” .pcap file, but you were not able to find any issues How can you explain this?

The “datagrams- pcap file only contains me successful tests Failed tests are contained in the
“datagrams-failed” .pcap file

The UXI sensor could not upload the latest test results to the cloud, so the packet capture is outdated

The datagrams captured on the physical Ethernet interface are in a different .pcap file.

The default filers of the packet captures do not allow tailed tests to be captured by the sensor

Use Free HPE7-A07 Exam Questions that Stimulates Actual EXAM : https://www.examslabs.com/HP/Aruba-Certified-Professional/best-HPE7-A07-exam-dumps.html

Post date: 2024-07-21 13:06:13
Post date GMT: 2024-07-21 13:06:13
Post modified date: 2024-07-21 13:06:13
Post modified date GMT: 2024-07-21 13:06:13