NEW QUESTION 41
Exhibit.

Which statement is true given the following CLI output from a CX 6300?

NEW QUESTION 42
A deployment using AP-635S is connectedto a stack of CX 6300s as shown.

The output of the snow LACPinterfaces shews the following:

What is causing this issue?

NEW QUESTION 43
A customer wan a gateway connected to a device on gigabitethernet0/0/3 configures an Asset ID TLVon the device for inventory management.
Exhibit.

The customer mentions me Asset ID is not shown What is causing the issue?

NEW QUESTION 44
A customer is deploying a new warehouse with AP-634 APs inthe unitedStates with mobile devices that can operate in the 6GHz spectrum All testing and RF analyses were performed during the POC using AP-635 APs In a different location During the deployment, they noticed fewer 6GHz channels were broadcasting in the air.
Why would the AP-634 deployment have a lesser amount of broadcasting channels?

NEW QUESTION 45
You are testing the use of the automated port-access role configuration process using RadSec authentication over VXLAN. During your testing you observed that the RadSec connection will fan during the digital certificate exchange What would be the cause of this Issue?

NEW QUESTION 46
The ACME company has an AOS-CX 6200 switch stack with an uplink oversubscription ratio of 9.6:1. They are considering adding two more nodes to the stack without adding any additional uplinks due to cabling constraints One oftheir architects has expressed concerns that their critical UDP traffic from both wired and bridged AP clients will encounter packet drops.They have already applied the following configuration:



Which strategy will complement this solution to achieve their objective?

NEW QUESTION 47
Refer to the CLI output below:

What statement about the output above is correct?

NEW QUESTION 48
Which statement is true given the following CLIoutput from a CX 6300?

NEW QUESTION 49
A BGP routing tablecontains multiple routes to the same destination prefix.
Referring to the table below whichroutewould be marked with a “>” symbol?

NEW QUESTION 50
A customer’s infrastructure is set up to use both primary and secondary gateway clusters on the SSID profile based on best practices What is a valid cause tor having an equal spirt in APs connected to the primary and secondary gateway clusters?

NEW QUESTION 51
Exhibit.


After configuring VRRP between sw-1 and SW-2. you notice that both switches are showing as active. What could be the reason for this issue?

NEW QUESTION 52
A customer has deployed anAOS 10 mobilitygateway cluster consisting of three controllers at a single site The WLAN is configured to tunnel wireless device traffic to the AOS 10 mobilitycluster.The clients areauthorized to use WPA2-Personal.An end-userhas opened a ticket with the helpdesk stating they cannot connect their client device to the network.There are other devices currently associated with the SSID with no issues.

Reviewing the output, what Is the issue?

NEW QUESTION 53
Exhibit.

Which wireless connection phase has Just been completed?

NEW QUESTION 54
What directly affects the MCS used by wireless stations? (Select two.)

NEW QUESTION 55
After onboarding three new AOS 10 gateways using the full-setup methodinto the same Central group, a customer cannot log in to one of the gateways using the HPE Aruba Networking Central remote console due to an incorrect password.

NEW QUESTION 56
Which option shows the correct Banawidth Control for 1024 kbpsdown and 2048 Kops up for the SSID?

NEW QUESTION 57
A customer has interfering devices that are seen over the air. They contact you and ask you to configure RAPIDS to help identify interfering and rogue APs. HPE Aruba Networking Central identifies a rogue AP and displays the connected switch port.
How can HPE Aruba Networking Central identify which switch port the AP is connected to?

NEW QUESTION 58
Exhibit.

You updated your gateway to me most recent firmware However after the firmware was updated, the gateway could no longer connect to HPE Aruba Networking Central. Your corporate ITIL procedures require you to implement your backout plan. You connected a console cable to your gateway and saw the following prompt.
Cpxload#
in what order, do you need to execute the following commands to return to the previous firmware version?

NEW QUESTION 59
Exhibit.

What is me expected behavior for ARP traffic sent from H1?

NEW QUESTION 60
What is me recommended configuration to ensure link aggregation is consistent in a campus topology using VSX with two aggregation switches and downlinks to access switches?

NEW QUESTION 61
Your customer added third-party USB dongles to the USB ports of their AOS 10 access points. The customer uses AP-615 and AP-635 Each AP is connected with a Cat 6A cable to a CX 6300F Class 4 PoE switch All APs are in the same group in HPE Aruba Networking Central and share the same configuration However, many of the dongles do not come up.
Which option will solve this issue?

NEW QUESTION 62
You are troubleshooting a WLAN deployment with APs and gateways set up with an 802.1X tunneled SSIO.
End-users are complaining that they can’t connect to die enterprise SSID. Which possible AP tunnel states could be the cause of the Issue? (Select two.)

NEW QUESTION 63
Exhibit.

An engineer has applied the above configuration to R1 and R2 However the routers OSPF adjacency never progresses past the “EXSTART-DR” slate as shown below.

Which configuration action on either router will allow R1 and R2 to progress past the “EXSTART/DR” state?

NEW QUESTION 64
Your customer’s employees connected to a wired network are complaining about a poor user experience. The customer has UXI sensors deployed on their premises. These sensors nave been running for multiple months.
They are testing both the wired network (using the wired Interface of each sensor) and the wireless networks.
Your customer used the UXI dashboard to find the reason for the poor userexperience to find more details, the customer asked you to check the packet captures that have been downloaded from the sensors using the UXI dashboard.
From the zip file downloaded from the UXI sensors, you checked the “datagrams” .pcap file, but you were not able to find any issues How can you explain this?