[Jul-2024] Use Real NSE7_SDW-7.2 Dumps Free Sample Questions and Practice Test Engine [Q22-Q38] : Exams Labs Braindumps : http://blog.examslabs.com

NO.22 Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit A shows the SD-WAN performance SLA configuration, the SD-WAN rule configuration, and the application IDs of Facebook and YouTube. Exhibit B shows the firewall policy configuration and the underlay zone status.
Based on the exhibits, which two statements are correct about the health and performance of port1 and port2? (Choose two.)

The performance is an average of the metrics measured for Facebook and YouTube traffic passing through the member.

FortiGate is unable to measure jitter and packet loss on Facebook and YouTube traffic.

FortiGate identifies the member as dead when there is no Facebook and YouTube traffic passing through the member.

Non-TCP Facebook and YouTube traffic are not used for performance measurement.

NO.23 Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )

A peer ID is included in the first packet from the initiator, along with suggested security policies.

XAuth is enabled as an additional level of authentication, which requires a username and password.

A total of six packets are exchanged between an initiator and a responder instead of three packets.

The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.

NO.24 Refer to the exhibit.

Based on the exhibit, which two statements are correct about the health of the selected members? (Choose two.)

After FortiGate switches to active mode, FortiGate never fails back to passive monitoring.

During passive monitoring, FortiGate can’t detect dead members.

FortiGate can offload the traffic that is subject to passive monitoring to hardware.

FortiGate passively monitors the member if TCP traffic is passing through the member.

NO.25 Refer to the exhibits.

Exhibit A shows the SD-WAN rule status and the learned BGP routes with community 65000:10.
Exhibit B shows the SD-WAN rule configuration, the BGP neighbor configuration, and the route map
configuration.
The administrator wants to steer corporate traffic using routes tags in the SD-WAN rule ID 1.
However, the administrator observes that the corporate traffic does not match the SD-WAN rule ID 1.
Based on the exhibits, which configuration change is required to fix issue?

In the dcl-lab-rm route map configuration, set set-route-tag to 10.

In SD-WAN rule ID 1, change the destination to use ISDB entries.

In the BGP neighbor configuration, apply the route map dcl-lab-rm in the outbound direction.

In the dcl-lab-rm route map configuration, unset match-community.

NO.26 Refer to the exhibit.

Based on the exhibit, which action does FortiGate take?

FortiGate bounces port5 after it detects all SD-WAN members as dead.

FortiGate fails over to the secondary device after it detects all SD-WAN members as dead.

FortiGate brings up port5 after it detects all SD-WAN members as alive.

FortiGate brings down port5 after it detects all SD-WAN members as dead.

NO.27 Refer to the exhibit.

The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants
BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths.
However, when looking at the spoke routing table, the administrator does not see the prefixes from other
spokes and the additional paths.
Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so
spokes can learn other spokes prefixes and their additional paths? (Choose three.)

Setadditional-pathtosend

Enableroute-reflector-client

Setadvertisement-intervalto the number of additional paths to advertise

Setadv-additional-pathto the number of additional paths to advertise

Enablesoft-reconfiguration

NO.28 Which are three key routing principles in SD-WAN? (Choose three.)

FortiGate performs route lookups for new sessions only.

Regular policy routes have precedence over SD-WAN rules.

SD-WAN rules have precedence over ISDB routes.

By default, SD-WAN members are skipped if they do not have a valid route to the destination.

By default, SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member.

NO.29 Which two statements are true about using SD-WAN to steer local-out traffic? (Choose two.)

FortiGate does not consider the source address of the packet when matching an SD-WAN rule for local-out traffic.

By default, local-out traffic does not use SD-WAN.

By default, FortiGate does not check if the selected member has a valid route to the destination.

You must configure each local-out feature individually, to use SD-WAN.

NO.30 Refer to the exhibit.

Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?

All traffic from a source IP to a destination IP is sent to the same interface.

All traffic from a source IP is sent to the same interface.

All traffic from a source IP is sent to the most used interface.

All traffic from a source IP to a destination IP is sent to the least used interface.

NO.31 Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)

Specify a unique peer ID for each dial-up VPN interface.

Use different proposals are used between the interfaces.

Configure the IKE mode to be aggressive mode.

Use unique Diffie Hellman groups on each VPN interface.

NO.32 Refer to the exhibit.

Which conclusion about the packet debug flow output is correct?

The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet
was dropped.

The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was
dropped.

The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was
dropped.

The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet
was dropped.

NO.33 Refer to the exhibit.

Based on the exhibit, which two actions does FortiGate perform on traffic passing through port2? (Choose
two.)

FortiGate does not change the routing information on existing sessions that use a valid gateway, after a
route change.

FortiGate performs routing lookups for new sessions only, after a route change.

FortiGate always blocks all traffic, after a route change.

FortiGate flushes all routing information from the session table, after a route change.

NO.34

Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)

The traffic shaper drops packets if the bandwidth is less than 2500 KBps.

The measured bandwidth is less than 100 KBps.

The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.

The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.

NO.35 Refer to the exhibit.

The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured packet loss will make T_INET_1_0 the new preferred member?