[Q12-Q30] Verified NSE7_EFW-7.2 dumps Q&As - Pass Guarantee or Full Refund [Aug-2024] : Exams Labs Braindumps : http://blog.examslabs.com

This page was exported from Exams Labs Braindumps [ http://blog.examslabs.com ]
Export date: Sat Sep 21 5:40:14 2024 / +0000 GMT

[Q12-Q30] Verified NSE7_EFW-7.2 dumps Q&As - Pass Guarantee or Full Refund [Aug-2024]

Verified NSE7_EFW-7.2 dumps Q&As - Pass Guarantee or Full Refund [Aug-2024]

NSE7_EFW-7.2 PDF Dumps | Aug 03, 2024 Recently Updated Questions

NO.12 Exhibit.

Refer to the exhibit, which contains the partial ADVPN configuration of a spoke.
Which two parameters must you configure on the corresponding single hub? (Choose two.)

Set auto-discovery-sender enable

Set ike-version 2

Set auto-discovery-forwarder enable

Set auto-discovery-receiver enable

NO.13 After enabling IPS you receive feedback about traffic being dropped.
What could be the reason?

Np-accel-mode is set to enable

Traffic-submit is set to disable

IPS is configured to monitor

Fail-open is set to disable

NO.14 You want to improve reliability over a lossy IPSec tunnel.
Which combination of IPSec phase 1 parameters should you configure?

fec-ingress and fec-egress

Odpd and dpd-retryinterval

fragmentation and fragmentation-mtu

keepalive and keylive

NO.15 Exhibit.

Refer to the exhibit, which contains an active-active toad balancing scenario.
During the traffic flow the primary FortiGate forwards the SYN packet to the secondary FortiGate.
What is the destination MAC address or addresses when packets are forwarded from the primary FortiGate to the secondary FortiGate?

Secondary physical MAC port1

Secondary virtual MAC port1

Secondary virtual MAC port1 then physical MAC port1

Secondary physical MAC port2 then virtual MAC port2

NO.16 Refer to the exhibit, which shows a network diagram.

Which IPsec phase 2 configuration should you impalement so that only one remote site is connected at any time?

Set route-overlap to allow.

Set single-source to enable

Set route-overlap to either use-new or use-old

Set net-device to enable

NO.17 Which two statements about metadata variables are true? (Choose two.)

You create them on FortiGate

They apply only to non-firewall objects.

The metadata format is $<metadata_variabie_name>.

They can be used as variables in scripts

NO.18 You contoured an address object on the tool fortiGate in a Security Fabric. This object is not synchronized with a downstream device. Which two reasons could be the cause? (Choose two)

The address object on the tool FortiGate has fabric-object set to disable

The root FortiGate has configuration-sync set to enable

The downstream TortiGate has fabric-object-unification set to local

The downstream FortiGate has configuration-sync set to local

NO.19 Refer to the exhibit, which shows an error in system fortiguard configuration.

What is the reason you cannot set the protocol to udp in config system fortiguard?

FortiManager provides FortiGuard.

fortiguard-anycast is set to enable.

You do not have the corresponding write access.

udp is not a protocol option.

NO.20 Exhibit.

Refer to the exhibit, which contains the partial ADVPN configuration of a spoke.
Which two parameters must you configure on the corresponding single hub? (Choose two.)

Set auto-discovery-sender enable

Set ike-version 2

Set auto-discovery-forwarder enable

Set auto-discovery-receiver enable

NO.21 Which two statements about the Security fabric are true? (Choose two.)

FortiGate uses the FortiTelemetry protocol to communicate with FortiAnatyzer.

Only the root FortiGate sends logs to FortiAnalyzer

Only FortiGate devices with configuration-sync receive and synchronize global CMDB objects that the toot FortiGate sends

Only the root FortiGate collects network topology information and forwards it to FortiAnalyzer

NO.22 Exhibit.

Refer to the exhibit, which contains an active-active toad balancing scenario.
During the traffic flow the primary FortiGate forwards the SYN packet to the secondary FortiGate.
What is the destination MAC address or addresses when packets are forwarded from the primary FortiGate to the secondary FortiGate?

Secondary physical MAC port1

Secondary virtual MAC port1

Secondary virtual MAC port1 then physical MAC port1

Secondary physical MAC port2 then virtual MAC port2

NO.23 Refer to the exhibit.

which contains a partial configuration of the global system. What can you conclude from this output?

NPs and CPs are enabled

Only CPs arc disabled

Only NPs are disabled

NPs and CPs arc disabled

NO.24 Exhibit.

Refer to the exhibit, which shows a partial touting table
What two concisions can you draw from the corresponding FortiGate configuration? (Choose two.)

IPSec Tunnel aggregation is configured

net-device is enabled in the tunnel IPSec phase 1 configuration

OSPI is configured to run over IPSec.

add-route is disabled in the tunnel IPSec phase 1 configuration.

NO.25 Exhibit.

Refer to the exhibit, which shows a partial web filter profile conjuration What can you cone udo from this configuration about access towww.facebook, com, which is categorized as Social Networking?

The access is blocked based on the Content Filter configuration

The access is allowed based on the FortiGuard Category Based Filter configuration

The access is blocked based on the URL Filter configuration

The access is hocked if the local or the public FortiGuard server does not reply

NO.26 Which ADVPN configuration must be configured using a script on fortiManager, when using VPN Manager to manage fortiGate VPN tunnels?

Enable AD-VPN in IPsec phase 1

Disable add-route on hub

Configure IP addresses on IPsec virtual interlaces

Set protected network to all

NO.27 Exhibit.

Refer to the exhibit, which contains an ADVPN network diagram and a partial BGP con figuration Which two parameters Should you configure in config neighbor range? (Choose two.)

set prefix 172.16.1.0 255.255.255.0

set route reflector-client enable

set neighbor-group advpn

set prefix 10.1.0 255.255.255.0

NO.28 Exhibit.

Refer to the exhibit, which shows information about an OSPF interlace
What two conclusions can you draw from this command output? (Choose two.)

The port3 network has more man one OSPF router

The OSPF routers are in the area ID of 0.0.0.1.

The interfaces of the OSPF routers match the MTU value that is configured as 1500.

NGFW-1 is the designated router

NO.29 You want to block access to the website ww.eicar.org using a custom IPS signature.
Which custom IPS signature should you configure?

NO.30 Exhibit.

Refer to the exhibit, which contains a partial VPN configuration.
What can you conclude from this configuration1?

FortiGate creates separate virtual interfaces for each dial up client.

The VPN should use the dynamic routing protocol to exchange routing information Through the tunnels.

Dead peer detection s disabled.

The routing table shows a single IPSec virtual interface.

NSE7_EFW-7.2 Exam Questions – Valid NSE7_EFW-7.2 Dumps Pdf: https://www.examslabs.com/Fortinet/NSE-7-Network-Security-Architect/best-NSE7_EFW-7.2-exam-dumps.html

Post date: 2024-08-03 09:43:49
Post date GMT: 2024-08-03 09:43:49
Post modified date: 2024-08-03 09:43:49
Post modified date GMT: 2024-08-03 09:43:49