QUESTION 22
Exhibit.

Referring to the exhibit, why is the active source field blank for the entry that uses the 00:0c:29:e8:b7:39 MAC address?

QUESTION 23
Exhibit.

Referring to the exhibit, Host1 (10.1.1.1) is failing to communicate with Host2 (10.1.2.1) in a data center that uses an ERB architecture. What do you determine from the output?

QUESTION 24
In your EVPN-VXAN environment, you want to prevent a multihomed server from receiving multiple copies ofBUM traffic in active/active scenarios. Which EVPN route type would satisfy this requirement?

QUESTION 25
Exhibit.

You are troubleshooting a DCI connection to another data center The BGP session to the provider is established, but the session to Border-Leaf-2 is not established. Referring to the exhibit, which configuration change should be made to solve the problem?

QUESTION 26
You are deploying multiple Juniper switches al the same location. Your switches are currently using the factory-default configuration.
In this scenario, which two statements are correct? (Choose two.)

QUESTION 27
Exhibit.

Referring tothe exhibit, which statement is correct?

QUESTION 28
Exhibit.

You want to enable the border leaf device to send Type 5 routes of local networks to the border leaf device in another data center. What must be changed to the configuration shown in the exhibit to satisfy this requirement?

QUESTION 29
Exhibit.

Referring to the configuration shown in the exhibit, assume that there is no external router present, and that the configuration is fabric-only.
Which two statements are true about the example configuration? (Choose two.)

QUESTION 30
You are asked for TX and RX traffic statistics for each interface to which an application server is attached.
The statistics need to be reported every five seconds. Using the Junos default settings, which telemetry method would accomplish this request?

QUESTION 31
You are asked to configure telemetry on the OFX Series devices in your data center fabric. You want to use sensors that have a vendor-neutral data model Which type of sensor should you use in this scenario?

QUESTION 32
You want to convert an MX Series router from a VXLAN Layer 2 gateway to a VXLAN Layer 3 gateway for VNI 100. You have already configured an IRB interface. In this scenario, which command would you use to accomplish this task?

QUESTION 33
You are asked to interconnect two of your company’s data centers across the IP backbone. Both data centers have their own unique IP space and do not require any bridging. In this scenario, which two actions would accomplish this task? (Choose two.)

QUESTION 34
You are asked to interconnect two of your company’s data centers across an IP backbone. Both data centers require Layer 2 and Layer 3 connectivity. In this scenario, which three actions would accomplish this task?
(Choose three.)

QUESTION 35
Which two statements are correct about an IP fabric? (Choose two.)

QUESTION 36
You are deploying an IP fabric using EBGP and notice that your leaf devices areadvertising and receiving all the routes. However, the routes are not installed in the routing table and are marked as hidden.
Which two statements describe how to solve the issue? (Choose two.)

QUESTION 37
Which three statements are correct about symmetric IRB routing with EVPN Type 2 routes? (Choose three.)

QUESTION 38
Whatare two supported methods (or exporting data when using the Junos telemetry interface? (Choose two.)

QUESTION 39
Exhibit.

You have a sample configuration for connecting two sites through EVPN-VXLAN by exchanging IP prefix routes.
Referring to the exhibit, which two statements regarding the configuration are true? {Choose two.)

QUESTION 40
You are using E8GP peering in an underlay IP fabric. Which two statements are correct in this scenario?
(Choose two.)

QUESTION 41
You are asked to interconnect Iwo data centers using a method that provides EVPN Type 2 connectivity, is highly scalable, and limits VXLAN tunnels between border leafdevices. What will satisfy these requirements?