2023 New HPE7-A01 Dumps – Real HP Exam Questions [Q26-Q49]

5/5 - (3 votes)

2023 New HPE7-A01 Dumps – Real HP Exam Questions

Dependable HPE7-A01 Exam Dumps to Become HP Certified

Q26. You are troubleshooting an issue with a pair of Aruba CX 8360 switches configured with VSX Each switch has multiple VRFs. You need to find the IP address of a particular client device with a known MAC address You run the “show arp” command on the primary switch in the pair but do not find a matching entry for the client MAC address.
The client device is connected to an Aruba CX 6100 switch by VSX LAG.
Which action can be used to find the IP address successfully?

 
 
 
 

Q27. List the WPA 4-Way Handshake functions in the correct order.

Q28. Refer to Exhibit:

With Access-1, What needs to be identically configured With MSTP to load-balance VLANS?

 
 
 
 

Q29. What is a primary benefit of BSS coloring?

 
 
 
 

Q30. How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?

 
 
 
 

Q31. List the firewall role derivation flow in the correct order

Q32. Which feature allows the device to remain operational when a remote link failure occurs between a Gateway cluster and a RADIUS server that is either in the cloud or a datacenter?

 
 
 
 

Q33. With the Aruba CX 6000 24G switch with uplinks of 1/1/25 and what does the switch do when a client port detects a loop and the do-not-disabie parameter is used?

 
 
 
 

Q34. You need to ensure that voice traffic sent through an ArubaOS-CX switch arrives with minimal latency What is the best scheduling technology to use for this task?

 
 
 
 

Q35. Match the topics with the underlying technologies (Options may be used more than once or not at all.)

Q36. Which statement best describes QoS?

 
 
 
 

Q37. What is enabled by LLDP-MED? (Select two.)

 
 
 
 
 

Q38. A system engineer needs to preconfigure several Aruba CX 6300 switches that will be sent to a remote office An untrained local field technician will do the rollout of the switches and the mounting of several AP-515s and AP-575S. Cables running to theAPs are not labeled.
The VLANs are already preconfigured to VLAN 100 (mgmt), VLAN 200 (clients), and VLAN 300 (guests) What is the correct configuration to ensure that APs will work properly?

 
 
 
 

Q39. Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?

 
 
 
 

Q40. your customer has asked you to assign a switch management role for a new user The customer requires the user role to View switch configuration information and have access to the PUT and POST meth0ds for REST API.
Which default AOS-CX user role meets these requirements?

 
 
 
 

Q41. Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements After the configuration was complete, it was noted that a user assigned with the administrators role did not have the appropriate level of access on the switch.
The user was not limited to viewing nonsensitive configuration information and a level of 1 was not assigned to their role Which default management role should have been assigned for the user?

 
 
 
 

Q42. Your customer is having issues with Wi-Fi 6 clients staying connected to poor-performing APs when a higher throughput APs are closer. Which technology should you implement?

 
 
 
 

Q43. What steps are part of the Key Management workflow when a wireless device is roaming from AP1 to AP2?
(Select two.)

 
 
 
 
 

Q44. In AOS 10. which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations”? The wired host ingress traffic arrives on a trusted port.

 
 
 
 

Q45. For the Aruba CX 6400 switch, what does virtual output queueing (VOQ) implement that is different from most typical campus switches?

 
 
 
 

Q46. With the Aruba CX 6100 48G switch with uplinks of 1/1/47 and 1/1/48. how do you automate the process of resuming the port operational state once a loop on a client port is cleared?

 
 
 
 

Q47. Which statement best describes QoS?

 
 
 
 

Q48. You are building a configuration in Central that will be used for a standardized network design for small sites for your company, you want to use GUI configuration for gateways and Aps, while template configuration for switches. You need to align with Aruba best practices.
Which set of actions will satisfy these requirements?

 
 
 
 

Q49. You are helping an onsite network technician bring up an Aruba 9004 gateway with ZTP for a branch office The technician was to plug in any port for the ZTP process to start Thirty minutes after the gateway was plugged in new users started to complain they were no longer able to get to the internet. One user who reported the issue stated their IP address is 172.16 0.81 However, the branch office network is supposed to be on 10.231 81.0/24.
What should the technician do to alleviate the issue and get the ZTP process started correctly?

 
 
 
 

Get Ready with HPE7-A01 Exam Dumps (2023): https://www.examslabs.com/HP/Aruba-Certified-Professional/best-HPE7-A01-exam-dumps.html