[Apr 15, 2025] Senior-Internal-Corrosion-Technologist Exam Dumps – Try Best Senior-Internal-Corrosion-Technologist Exam Questions – ExamsLabs [Q21-Q43]

QUESTION 21
In powder coatings, when the particles of powder begin to flow but are not fully liquid, they are in what stage?

QUESTION 22
On pipelines, which coating is Identifiable by Its distinct colors, usually light blue, green, or grey?

QUESTION 23
Differences in technique for abrasive blasting concrete versus steel require the operator to:

QUESTION 24
You are the NACE Level 2 Inspector with the final responsibility to prepare the final report for a very large structural steel shop project which has gone very well. It Is due next week. The work has been ongoing for two years and several NACE Level 1 Inspectors have worked under your supervision throughout the project.
You find you are missing one week of daily reports for the night shift from the very beginning of the project and despite your best efforts they are cannot be found.
You FIRST preferred course of action Is to:

QUESTION 25
Measuring methyl ethyl ketone (MEK) resistance of ethyl silicate Inorganic zinc-rich primers by solvent rub requires

QUESTION 26
Pre-cleaning of work pieces will NOT remove

QUESTION 27
The Inspectors’ goal at the Pre-Job Conference is to:

QUESTION 28
Non-Conformance Reports are designed to:

QUESTION 29
You are the new NACE Level 2 Inspector on a Job which had been very problematic. The previous Inspector was fired due to personality conflicts with the Contractor’s supervisor. Upon arriving onsite the Contractor’s supervisor advises you In no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action Is to:

QUESTION 30
The number of air turns in an enclosure can be affected by all of these EXCEPT

QUESTION 31
W3-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PS1)

QUESTION 32
When observing design defects the NACE Inspector should:

QUESTION 33
The cost of qualified Coating Inspection Is normally offset by:

QUESTION 34
NACE Level 2 Inspectors have been authorized to perform:

QUESTION 35
You have Just received your NACE CIP Level 2 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

QUESTION 36
When a coating is expected to be exposed to temperatures above 93C (200 F) the best choice would be:

QUESTION 37
Inspection and Test Plans are provided to:

QUESTION 38
As a NACE Level 2 Inspector on a field Job; prior to submission your documentation should always be reviewed and approved by:

QUESTION 39
Generally,for safety considerations, waterjetting hose connections use

QUESTION 40
Which standards are generally established by private-sector bodies and are available for use by any person or organization, private or government?

QUESTION 41
Surface preparation methods for Non-ferrous metals are:

QUESTION 42
You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved.
Your FIRST preferred course of action is to:

QUESTION 43
Which is used to calibrate a pH meter?