새 질문 50
When investigating FortiGuard connectivity issues, which action is a valid troubleshooting step?

새 질문 51
Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.)

새 질문 52
Refer to the exhibit, which contains the partial output of a diagnose command.


Based on the output, which two statements are correct? (Choose two.)

새 질문 53
Which three conditions are required for two FortiGate devices to form an OSPF adjacency? (Choose three.)

새 질문 54
Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems?

새 질문 55
Which two tasks are automated using the Import Configuration wizard on FortiManager? (Choose two.)

새 질문 56
Which of the following conditions must be met for a static route to be active in the routing table?
(3개 선택)

새 질문 57
What does the dirty flag mean in a FortiGate session?

새 질문 58
Examine the following partial output from a sniffer command; then answer the question below.

What is the meaning of the packets dropped counter at the end of the sniffer?

새 질문 59
View the exhibit, then answer the question below.

Which of the following commands will bring up the tunnel?

새 질문 60
Refer to the exhibit, which shows the output of a debug command.

출력에 대한 다음 두 문장은 모두 참입니까? (두 개를 선택하세요.)

새 질문 61
View the exhibit, which contains the output of a debug command, and then answer the question below:

What statement is correct about this FortiGate?

새 질문 62
Refer to the exhibit, which shows a session entry.

Which statement about this session is true?

새 질문 63
Which two statements about FortiManager is true when it is deployed as a local FDS? (Choose two.)

새 질문 64
Refer to the exhibit, which shows the output of a debug command.

What can be concluded from the debug command output?

새 질문 65
Refer to the exhibit, which contains a CLI script configuration on FortiManager.

An administrator configured the CLI script on FortiManager, but the script failed to apply any changes to the managed device after being executed.
What are two reasons why the script did not make any changes to the managed device? (Choose two.)

새 질문 66
다음 전시회를 확인하세요:

Which two statements about the BGP peer are true? (Choose two.)

새 질문 67
An administrator added the following Ipsec VPN to a FortiGate configuration:
configvpn ipsec phasel -interface
edit “RemoteSite”
set type dynamic
set interface “portl”
set mode main
set psksecret ENC LCVkCiK2E2PhVUzZe
next
end
config vpn ipsec phase2-interface
edit “RemoteSite”
set phasel name “RemoteSite”
set proposal 3des-sha256
next
end
However, the phase 1 negotiation is failing. The administrator executed the IKF real time debug while attempting the Ipsec connection.
The output is shown in the exhibit.

What is causing the IPsec problem in the phase 1?