Achieve the NACE-CIP1-001 Exam Best Results with Help from NACE Certified Experts [Q14-Q38]

NO.14 An Inspector should change position when:

NO.15 When performing tests for oil and grease using an ultra-violet light, the NACE Inspector should be aware that:

NO.16 On a blast-cleaned surface, Ian ultraviolet light is generally used to detect

NO.17 ISO ST 3 is described as:

NO.18 Non Conformance Reports are completed by the Inspector:

NO.19 The primary difference between Non-Convertible vs. Convertible coatings is:

NO.20 In the event of a conflict between the project specification and the coating manufactures’ product data sheet, the Inspector’s first course of action should be too:

NO.21 Prior to using Inspection Tools the inspector must:

NO.22 SSPC SP 1 identifies the use of:

NO.23 You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

NO.24 If inspectors identify issues of non-conformance during an inspection, they should

NO.25 NACE No. 4/SSPC-SP-7 is a joint standard for

NO.26 When applying Thermal Spray Coatings the specification is most likely to refence:

NO.27 To achieve consistently accurate results with ALL alt test equipment

NO.28 Fine cracks in the surface of a coating that rarely reach the substrate are called

NO.29 NACE Level 1 Inspectors have been trained to perform:

NO.30 What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

NO.31 When using a sling physchrometer a very large difference between the wet and dry bulb readings indicates:

NO.32 An exposed area of the substrate or previous coat of a conductive coating material, often caused by poor application technique is called

NO.33 Using SSPC Vis 1 as a guide when performing a visual inspection of a steel surface prior to surface preparation a NACE Inspector would assign which designations to the surface condition:

NO.34 The Inspector should record the serial numbers of inspection instruments:

NO.35 Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Off Dry Filth Thickness (DFT) gauge include:
Select All That Apply

NO.36 Good records can provide maintenance departments with detailed information about ALL of the following EXCEPT

NO.37 The most important factor resulting in improved job site safety is:

NO.38 ASTM Standards are applicable: