[May 19, 2026] JN0-232 Dumps PDF and Test Engine Exam Questions – ExamsLabs [Q14-Q32]

NEW QUESTION 14
Which two statements are correct about security zones? (Choose two.)

NEW QUESTION 15
You want to show the effectiveness of your SRX Series Firewall content filter.
Which operational mode command would you use in this scenario?

NEW QUESTION 16
Content filtering supports which two of the following protocols? (Choose two.)

NEW QUESTION 17
Your manager asks you to verify when your antivirus definitions were last updated on your SRX Series Firewall.
Which operational mode command allows you to see this information?

NEW QUESTION 18
Which two characteristics of destination NAT and static NAT are correct? (Choose two.)

NEW QUESTION 19
Which two statements are correct about NAT and security policy processing? (Choose two.)

NEW QUESTION 20
You want to use Avira Antivirus.
Which two actions should you perform to satisfy this requirement? (Choose two.)

NEW QUESTION 21
You are asked to create a security policy that controls traffic allowed to pass between the Internet and private security zones. You must ensure that this policy is evaluated before all other policy types on your SRX Series device.
In this scenario, which type of security policy should you create?

NEW QUESTION 22
You are asked to reduce security configuration complexity on your external facing firewalls. You notice that a previous administrator included hundreds of private subnet NAT rules covering various RFC1918 addresses.
You want to replace all these rules with a single rule covering all RFC1918 addresses.
Which rule would you use in this scenario?

NEW QUESTION 23
You want to confirm that your SRX Series Firewall is connected to the SBL server.
Which operational mode command would you use in this scenario?

NEW QUESTION 24
You are troubleshooting first path traffic not passing through an SRX Series Firewall. You have determined that the traffic is ingressing and egressing the correct interfaces using a route lookup.
In this scenario, what is the next step in troubleshooting why the device may be dropping the traffic?

NEW QUESTION 25
Which two security policies are installed by default on SRX 300 Series Firewalls? (Choose two.)

NEW QUESTION 26
Which zone configuration is required to permit transit traffic?

NEW QUESTION 27
What must also be enabled when using source NAT if the address pool is in the same subnet as the interface?

NEW QUESTION 28
Click the Exhibit button.

You must ensure that sessions can only be established from the external device.
Referring to the exhibit, which type of NAT is being performed?

NEW QUESTION 29
Your company is acquiring a smaller company that uses the same private address range that your company currently uses in its North America division. You have a limited number of public IP addresses to use for the acquisition. You want to allow the new acquisition’s users to connect to the existing services in North America.
Which two features would you enable on your SRX Series Firewall to accomplish this task? (Choose two.)

NEW QUESTION 30
Click the Exhibit button.

Referring to the exhibit, which two statements are correct about the traffic flow shown in the exhibit? (Choose two.)

NEW QUESTION 31
You are troubleshooting traffic traversing the SRX Series Firewall and require detailed information showing how the flow module is handling the traffic.
How would you accomplish this task?

NEW QUESTION 32
Which two statements are true about the NextGen Web Filtering (NGWF) feature on an SRX Series device?
(Choose two.)