300-610 Dumps with Practice Exam Questions Answers [Q100-Q124]

QUESTION 100
Which protocol prevents fiber failures from causing a Layer 2 loop in a dark fiber DCI?

QUESTION 101
A large financial institution hosts all customer data in a critical data center with a single physical location. Top management is concerned about the risk of a single-site failure, but budget is also an issue, so the network engineering team is working to implement a cost-effective redundancy strategy with a second data center. The new data center must use a three-tier design identical to the existing data center. Business requirements dictate that all data must always be accessible from anywhere in the world, even if a single site fails. The team purchased two Cisco Nexus 7700 Series Switches and four Catalyst 8000 Series Routers. Which action must the team take to accomplish the goal?

QUESTION 102
A network engineer is using a Cisco UCS environment connected to a Fibre Channel storage array. The Cisco UCS environment must be connected to an existing SAN network, and several Cisco MDS 9000 Series Switches must be added to increase storage density. The solution must not exhaust the SAN network from the list of available domain IDs after connecting Also, most of the SAN traffic must be mapped from the Cisco UCS blades to a specific group of the fabric interconnect ports Which two features must be deployed to meet these requirements? (Choose two.)

QUESTION 103
An engineer must design a multitenant solution using Cisco 7709 switches. The solution must support separate routing instances, separate spanning tree domains, and separate firewalls for each tenant.
Which solution meets these requirements?

QUESTION 104
Drag the appropriate from the left onto the current UDLD modes of operation on the right.

QUESTION 105
Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?

QUESTION 106
A Cisco engineer is configuring a Cisco UCS integrated infrastructure for SAP HANA that consists of 8 x Cisco UCS B/C480-M5 servers for SAP HAN A and 4 x Cisco UCS C240-M5 C-Series rack mount servers for storage. The rack servers are equipped with Cisco VIC 1225T. The engineer plans to install RHEL8. but the boot process is interrupted at installation because the iSCSl LUNs are not recognized by the VIC adapter. After proper Investigation, the engineer concludes that the initiator and target configuration that is programmed on the primary ISCSl VNIC to the operating system Is missing. What is the reason for the issue?

QUESTION 107
Refer to the exhibit.

An engineer must assign multiple Fibre Channel IDs to a single port channel. Which two features must be enabled this goal? (Choose two.)

QUESTION 108
A networking team must implement a new management solution for the network devices at their organization. The solution must meet these requirements
* It must enable seamless monitoring, configuration, and troubleshooting while ensuring security and reliability.
* It must allow access to devices even if the production network is down.
* It must be easy to use and manage.
The company’s budget is limited. Which implementation must the team perform to meet the requirements?

QUESTION 109
Refer to the exhibit. A customer requires a VXLAN fabric deployment with these requirements:
– DNS must be a shared service.
– Users will not require direct sharing of resources with other users.
– The deployment must use the least configuration intensive approach to achieve route leaking.
Which action must the customer take to meet these criteria?

QUESTION 110
Refer to the exhibit. A Cisco engineer is configuring a data center design scenario with Cisco MDS 90Q0 Series Switches. The cut-through routing mode is chosen for impf oved read operation performance. Each (SCSI host requires access lo storage through the IPS module. First, the engineer configures the TCP tuning parameters as enabled SACK, the maximum bandwidth of 1 Gbps. buffer size of 4096. keepalive timeout at
1s. and enables Path MTU. Then, the engineer must set the OoS of the ISCSI link. What is the maximum QoS value that must be set tor the ISCSI session?

QUESTION 111
A network architect designs a high-availability architecture for the Cisco UCS Fabric interconnects that installed in a data center. The architecture must support clustering and redundancy. Which architecture meets these requirements?

QUESTION 112
Which authentication software natively runs within the CLI of Cisco NX-OS devices?

QUESTION 113
Drag the appropriate from the left onto the current UDLD modes of operation on the right.

QUESTION 114
A network engineer must design a Cisco HyperFlex solution based on these requirements:
* two clusters in the main data center consisting of five HyperFlex nodes
* one edge node for the remote branch
* cluster nodes that use one rack unit of space
Which two devices should be used in the remote branch cluster for this design? (Choose two.)

QUESTION 115
A network consultant evaluates the Cisco UCS Fabric Interconnect SAN configuration, which must meet these requirements:
– All traffic must pass over the upstream device for switching and
domain IDs must be preserved in the fabric.
– Each server should be pinned to one designated upstream interface and for the traffic to pass through the pinned port.
Which Fabric Interconnect SAN operational mode meets these requirements?

QUESTION 116
A engineer wants to eliminate the manual process of checking the system hardware and firmware against a specified hardware compatibility tool. The tool must be able to manage an extensive list of devices including cisco HyperFlex, MDS, and Nexus switches. The tool must manage hardware in multiple data centers so it should be deployed on public cloud infrastructure. Which tool meets these requirements?

QUESTION 117
Drag and drop the technologies from the left onto the correct descriptions on the right.

QUESTION 118
Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.

QUESTION 119
Which two configurations allow for routing traffic between two VDCs? (Choose two.)

QUESTION 120
Refer to the exhibit.

An engineer must connect the four-port Cisco UCS VIC adapter to the fabric extenders. Which connectivity implements a port-channel standalone mode?

QUESTION 121

Refer to the exhibit. A Cisco engineer is planning a data migration job in heterogeneous SANs where the existing and new storage devices for the migration are already connected to the MDS switches. All paths from the SSM to the storage-connected switch are going through the Cisco fabric. The setup is with active/active arrays and multiple LUN sets. What is the best approach to copy the LUN sets to the new location?

QUESTION 122
Which statement accurately describes a disjoint Layer 2 network topology in Cisco UCS infrastructure?

QUESTION 123
A company has several data centers with hundreds of Cisco UCS blade chassis. A network consultant plans to active Cisco Discovery Protocol to the servers to facilitate Layer 1 troubleshooting. For security reasons, the company wants to restrict the servers from sending different MAC addresses to the fabric interconnect after the MAC address from the first packet is learned. Which two policies be modified to support this design? (Choose two.)

QUESTION 124
Refer to the exhibit.

A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel. What is the result of this policy?