Valid DES-DD23 Exam Dumps Ensure you a HIGH SCORE (2022) [Q11-Q33]

Q11. Which component of PowerProtect DD is Data Invulnerability Architecture a feature of?

Q12. What is the order of steps to configure DD Boost on the backup host?

Q13. An administrator recognizes poor network performance when using CIFS shares from a PowerProtect DD system. The network link utilization is under 100%.
What is the most likely cause of this issue?

Q14. Backup administrators have noticed slow backups on the AIX environment.
To fix the issue, what should the set large_send be for each NIC, and what should the NFS option be set to?

Q15. An administrator monitors the performance statistics of a PowerProtect DD appliance. Low disk-write rates are shown, and the network inbound traffic is high.
What is the most likely cause of this behavior?

Q16. A PowerProtect DD appliance has been installed at a company’s location for several months and has reached a steady state.
As a best practice, at what percentage of disk utilization should action be taken?

Q17. What system role is required to create the second security officer for a PowerProtect DD?

Q18. What are some possible network bottlenecks for a PowerProtect DD?

Q19. Which are supported compression algorithms in DDOS?

Q20. An engineer is configuring a PowerProtect DD system for VTL using Fibre Channel. How should the zones be configured?

Q21. A customer needs an upgrade on their DD6900 to use HA.
Which expansion shelf is required?

Q22. Refer to the exhibit.

Match each action to its call-out location.

Q23. Which command is used to check if NFS is enabled?

Q24. Which PowerProtect DD procedure uses the DoD/NIST standards to provide data security?

Q25. A PowerProtect DD appliance with two expansion shelves is being installed in a customer-provided rack. When cabling the controller to the shelves, what is connected to the host port on the last shelf in the chain?

Q26. What is the maximum capacity for a DDVE?

Q27. What is a requirement to configure the PowerProtect DD tape out to cloud feature?

Q28. Which port/protocol is used when using a syslog server to monitor a PowerProtect DD system?

Q29. When using CIFS from a PowerProtect DD system, what should be changed on a Windows machine?

Q30. What is the correct sequence of operations used by the PowerProtect DD DIA in the end-to-end verification process?

Q31. An administrator is scaling Cloud Tier for a DD9400 by adding a second cloud unit. What is the required amount of metadata storage (TB)?

Q32. A backup administrator is tasked with verifying the compression savings of a PowerProtect DD9900. Which compression algorithm will they see enabled by default?